STUDI PENELITIAN PENGARUH PENAMBAHAN VARIASI PERSENTASE AIR TERHADAP SIFAT MEKANIS DAN SIFAT FISIS BETON F’C 30 MPA PRODUKSI READY MIX

  • Rafael Alexandro Djawa Nuwa
  • Ratri Andinisari ITN Malang

Abstract

The purpose of this research is to analyze the effect of adding variations of water percentage on the mechanical and physical properties of ready-mix concrete with a target strength of f’c 30 MPa. The additional water percentages used were 0%, 1%, 2%, 3%, and 4% of the planned water volume. The tests conducted included slump, compressive strength, modulus of elasticity, and porosity. This study employed an experimental method in the laboratory with cylindrical specimens measuring 15 cm × 30 cm. The results showed that adding up to 4% water generally increased the slump value, thereby improving the workability of concrete. However, this improvement was accompanied by a reduction in mechanical properties, where compressive strength recorded the largest decrease at the 4% variation, with a decline of 23.18% compared to the control condition. A similar trend was observed in the modulus of elasticity, which decreased by up to 11.47%. These findings indicate that additional water increases the water-cement ratio (w/c), leading to reduced concrete strength. On the other hand, the porosity value tended to increase but did not show a significant change, with an average of 0.1879% across all test specimens.

Downloads

Download data is not yet available.
Published
2026-10-30